구매 및 설치 가이드: SPC 바닥재의 품질 식별 및 시공 팁

SPC 바닥재의 품질 차이의 핵심은 모재 배합, 내마모층의 두께-, 생산 공정에 있습니다. 구매할 때 외관, 두께, 내마모성 층, 모재 밀도 및 환경 보호 테스트 측면에서 엄격한 검사를 거쳐야 합니다. 1. 외관: 고품질-품질의 바닥재는 깨끗하고 사실적인 표면 질감(나뭇결, 돌 질감, 카펫 질감을 시뮬레이션할 수 있음)을 가지며 긁힘, 기포, 색상 차이가 없고 접합 후 0.1mm 이하의 간격이 있으며 높이 차이가 없습니다. 2. 두께 : 가정 장식의 경우 6-8mm를 선택하고 상업용의 경우 8-10mm를 선택하십시오. 두께가 두꺼울수록 안정감이 좋아지고 발이 편한 느낌이 듭니다. 너무 얇은 경우(< 5mm), it is prone to cracking and has a hollow feeling when stepped on; 3. Wear-resistant layer: For household use, choose 0.3mm (AC3 grade), for kitchens and bathrooms, choose 0.5mm (AC4 grade), for commercial spaces with heavy foot traffic, choose 0.7mm (AC5 grade). If the wear-resistant layer is too thin, it is prone to wear and has a short lifespan; 4. Base material density: High-quality base materials have a density of ≥ 2.0g/cm³, with a hard texture that is not easily broken when bent by hand, and low-quality base materials have a low density and are soft, prone to deformation; 5. Environmental protection testing: Request an SGS test report to confirm that the formaldehyde and heavy metal content comply with the ENF standard, without any odor. Installation and construction should follow four steps: base treatment, pre-assembly, installation, and edge finishing. Ensure the effect and stability: 1. Base treatment: The ground should be flat (height difference ≤ 2mm/㎡), dry, clean, without sharp debris, and the old tile floor should clean the oil stains in the gaps; 2. Pre-assembly: After unpacking, place it in the room for 24 hours to adapt to the environmental temperature, pre-assembly in the direction of the texture, adjust the color difference, and avoid batch differences; 3. Installation: Start from the corner, use "locking connection, no glue fixation", leave a 5-8mm expansion joint between the boards (at the wall corner, door frame), to prevent warping due to thermal expansion and contraction; 4. Edge treatment: Install PVC baseboard at the wall corner, use a molding at the door frame and passageway, to enhance the aesthetic appeal and stability. Daily maintenance is simple: No need to wax or polish, clean dust with a broom or vacuum cleaner, use a damp cloth to wipe stains, and for stubborn stains, use a neutral cleaner; Avoid sharp objects scraping, when moving heavy objects, pad with a soft cloth to prevent scratching the surface; Maintain indoor ventilation for a long time, avoid direct sunlight for a long time, to delay fading and aging, the normal service life can reach more than 20 years.